Networking And Remote Control - Orban OPTIMOD-FM 8500S Operating Manual

2-44
INSTALLATION

Networking and Remote Control

• Analog Out Delay Out: Bypasses the diversity delay for a specified output
(Analog, Digital #1, Digital #2, Composite) emitting the output of the ana-
log FM processing chain (see page 3-67). D
D O 2 D
IGITAL UT
• FM Polarity Positive: Makes positive the output polarity of the 8500S's
FM analog channel processing. In HD Radio installations, this command is
useful when switching the 8500S between transmitters if the transmitters'
exciters produce opposite FM modulation polarities when driven by identi-
cal digital audio input signals. This setting affects any output emitting the
analog FM processed signal, including the composite output.
• FM Polarity Negative: (see above)
• No Function: remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape button to return to higher menu levels.
[Skip this step if you do not wish to connect to your 8500S remotely, either for
downloading software upgrades or for PC Remote Control.]
The 8500S has a built-in Ethernet connector that can be used with 10 Mbps or 100
Mbps ports using the TCP/IP protocol. You can also connect a PC to the 8500S
through the 8500S's RS-232 serial port, either by modem or directly through a null
modem cable.
1. Prepare the 8500S for an Ethernet network connection:
[Skip this step if you will not be using an Ethernet connection.]
See your network administrator to get the data required in the following proce-
dure.
Note that if you wish to do this from the 8500S PC Remote software, then you
must first be able to connect to the 8500S. Therefore, you will usually per-
form this procedure from the 8500S's front panel to prepare it for connec-
tion.
A) Navigate to Setup > N
B) Press the S IP A
ET
The IP Address Screen appears.
are also available.
O
ELAY UT
& R
ETWORK EMOTE
soft button.
DDRESS
O 1 D
IGITAL UT
> Next.
ORBAN MODEL
and
O
ELAY UT