Orban OPTIMOD-FM 8500S Operating Manual page 109

OPTIMOD-FM DIGITAL
In the above table:
•
If a non-existent control value and/or an invalid passcode is entered, the 8500S
will ignore the command.
•
You can apply this command anytime after the 8500S boots up. The 30-minute
timeout does not apply.
6. To fetch real-time operational status information from the Optimod:
This provides a real-time status report including the following information:
Command
RT [PASSCODE]
7. To fetch information about the active processing preset:
Command
AP [PASSCODE]?
AP [PASSCODE]??
LP [PASSCODE]
8. To fetch diagnostic information from the 8500S:
This provides a status report indicating technical parameters:
Command
ST [PASSCODE]
X = A, D
where A = analog input, D = digital input
PASSCODE = ANY VALID PASSCODE.
Response
8500S Status:
digital input 1 lock [active][inactive]
digital input 2 lock [active][inactive]
remote contact closure 1 [active][inactive]
remote contact closure 2 [active][inactive]
remote contact closure 3 [active][inactive]
remote contact closure 4 [active][inactive]
remote contact closure 5 [active][inactive]
remote contact closure 6 [active][inactive]
remote contact closure 7 [active][inactive]
remote contact closure 8 [active][inactive]
tally out 1 [active][inactive]
tally out 2 [active][inactive]
Response
Returns active processing preset name
Returns active
settings
Returns a list of all available processing
presets
Response
8500S Status:
Ver. 1.0.x.x Bootrom: 4
mmm. dd, yyyy HH:MM:SS
processing preset
2-53
INSTALLATION
control