Orban OPTIMOD-FM 8500S Operating Manual page 101

OPTIMOD-FM DIGITAL
a) Use the Next and Prev keys to move the cursor in turn to each digit in the IP
address. Use the knob to set the digit to the desired value. Repeat until you
have selected all the numbers in the IP address assigned by your network
administrator
b) Press the S
C) Set the Subnet Mask assigned by your network administrator if necessary:
a) Press the S
b) Use the Next and Prev keys to move the cursor in turn to each digit in the
subnet mask. Use the knob to set the digit to the desired value. Repeat
until you have selected all the numbers in the subnet mask assigned by
your network administrator
c) Press the S
D) Set the Gateway Address assigned by your network administrator if necessary:
a) Press the G
b) Use the Next and Prev keys to move the cursor in turn to each digit in the
gateway address. Use the knob to set the digit to the desired value. Repeat
until you have selected all the numbers in the gateway address assigned by
your network administrator
c) Press the S
E) Set the IP Port assigned by your network administrator if necessary:
a) Press the IP P
b) Use the Next and Prev keys to move the cursor in turn to each digit in the IP
port. Use the knob to set the digit to the desired value. Repeat until you
have selected all the numbers in the IP port assigned by your network
administrator
c) Press the S
F) Connect your Ethernet network to the RJ45 jack on the rear panel of your
8500S.
•
If you are connecting to a hub or router, use a standard Ethernet cable.
•
If you are connecting directly to the Ethernet jack on a computer, use a "cross-
over" or "reverse" Ethernet cable.
G) Press the Next button.
2. Prepare the 8500S for modem connection through the serial port:
[Skip this step if you will not be using a modem connection.]
A) Navigate to Setup > N
B) Hold down the PC C
on the display.
M
ODEM
soft button to confirm your setting.
AVE
soft button.
S M
ET UBNET ASK
soft button to confirm your setting.
AVE
soft button.
A
ATEWAY DDRESS
soft button to confirm your setting.
AVE
soft button.
ORT
soft button to confirm your setting.
AVE
& R
ETWORK EMOTE
soft button and turn the knob until you see
ONNECT
.
2-45
INSTALLATION