Security And Passcode Programming; Programming A Passcode - Orban Optimod-AM 9200 Operating Manual Addendum

OPTIMOD-AM 9200
System Setup Page 2:
System Setup Page 3:
POS PEAK
100%

Security and Passcode Programming

[Skip this section if you do not wish to change the security level of program passcodes at
the time and you are not using 9200 PC Remote software.]
The 9200 has a relatively simple security system. The same passcode is used for
local and remote security. If you plan to use 9200 PC Remote software, you must
set a passcode so that the software can connect to your 9200. If you do not plan to
use 9200 PC Remote software, setting a passcode is optional.
A timer that locks out the front panel after a certain period of control inactivity
achieves local protection of the 9200. The
ture.

Programming a Passcode

To program a passcode, complete the following steps:
1. Program the passcode
Press the
A) Setup
I/O
CALIB
B) Press the REMOTE & SECURITY
SET MODEM
INIT
Press the
C) SET PASSCODE
SELECT CHARACTER WITH KNOB
Turn the knob until the desired number appears.
D)
A passcode can have one to eight numbers. Embedded spaces are not al-
ST CHASSIS
NO
button to access security controls
REMOTE &
SECURITY
soft button to access
REMOTE
INTERFACE
soft button to access the Set Passcode screen.
VERSION 3.0 SOFTWARE ADDENDUM
NITE MODE DAY/NITE
ENABLED
NITE MODE POS PEAK
100%
soft button activates this fea-
LOCKOUT
.
TEST
SET PASSCODE.
SET LOCKOUT
PASSCODE
PASSCODE
DAY
BAND
WIDTH
Off
SAVE
A-5