Day And Night Positive Peak Control - Orban Optimod-AM 9200 Operating Manual Addendum

A-4
OPTIMOD-AM 9200
high-power transmitters. Broadcasters transmitting primarily speech programming may
want to set this filter's cutoff frequency relatively high to further maximize tube life and
minimize power consumption.
The three HF presets are derived from two basic presets,
each with full
MAXIMUM
All presets are initially set for 4.5 kHz lowpass filtering, 50 Hz highpass filtering, and a
gentle bass rolloff. However, like any other 9200 factory preset, you can adjust these (and
many other) parameters and save the result to a user preset. For example, the 4.5 kHz
lowpass filter provides a very steep rolloff, so HF broadcasters may find that they can set
it to 5.0 kHz without causing objectionable adjacent-channel interference.
The 9200 has a bypass facility that includes the lowpass filter, highpass filter, and a safety
clipper (with user-settable threshold). This allows you to make transmission system
measurements through the 9200 while protecting high-power transmitters from damage
due to application of inappropriate levels or frequencies.
Orban's analog Optimod-HF 9105 has achieved widespread acceptance amongst the
world's most prestigious national HF broadcasting organizations. The HF 9200 presets
have been tuned to sound as close as possible to the 9105, and we believe that they will
be equally proficient

Day and Night Positive Peak Control

V 2.0 has separate day and night positive peak settings, providing you with the highest
fidelity during daytime broadcasts and the largest signal coverage at night, when higher
levels are processing are appropriate to cut through skywave interference.
In V 1.0 software, the
setting was applied to the output at all times. Version 2.0 replaces the single positive peak
control with separate
To accommodate both controls on a single screen,
tem Setup page 2 to a new page 3. When
control,
NITE MODE POSITIVE PEAK
The
POS PEAK
is enabled and
MODE
NITE MODE
Here is how the three System Setup Screens look in Version 2.0 and 3.0:
System Setup Page 1:
control. The third, "flame-thrower" preset called
LESS/MORE
is identical to HF VOICE
POS PEAK
POS PEAK controls for
setting is the active setting when
DAY/NITE
is enabled and
DAY/NITE
I/O REMOTE &
CALIB SECURITY
VERSION 3.0 SOFTWARE ADDENDUM
except for a much higher
control was on page 2 of the System Setup screen; this
day and nite
POS PEAK
is enabled, a second positive peak
NITE MODE
, is also available on System Setup page 3.
NITE MODE
is set to .
day NITE MODE POS PEAK
is set to .
nite
TEST
HF GENERAL and HF VOICE
LESS/MORE setting.
modes.
has been moved from Sys-
is disabled, or when
is active when
BAND
WIDTH
,
HF
NITE