Networking And Remote Control - Orban Optimod-FM 8300 Operating Manual

OPTIMOD-FM DIGITAL

Reset Clock To Hour: resets the internal clock to the nearest hour. For exam-
ple, 3:03:10 would be reset to 3:00:00, while 3:53:40 would be reset to 4:00:00.
Use this function to periodically re-sync the 8300's internal clock to your station's
master clock.

Reset Clock to Midnight: Resets the clock to 0:00:00. You can use this function
to periodically re-sync the 8300's internal clock to your station's master clock.

No Function: remote input is disabled.
3. End remote control interface programming.
When you are finished programming the remote control interface, press the Es-
cape button to return to higher menu levels.

Networking and Remote Control

[Skip this step if you do not wish to connect to your 8300 remotely, either for
downloading software upgrades or for PC Remote Control.]
The 8300 has a built-in Ethernet connector that can be used with 10 Mbps or 100
Mbps networks using the TCP/IP protocol. You can also connect a PC to the 8300
through the 8300's RS-232 serial port, either by modem or directly through a null
modem cable.
1. Prepare the 8300 for an Ethernet network connection:
[Skip this step if you will not be using an Ethernet connection.]

See your network administrator to get the data required in the following
procedure.

Note that if you wish to do this from the 8300 PC Remote software, then you
must first be able to connect to the 8300. Therefore, you will usually perform
this procedure from the 8300's front panel to prepare it for connection.
A) Navigate to S
B) Press the S
The IP Address Screen appears.
a) Use the N
IP address. Use the knob to set the digit to the desired value. Repeat until
you have selected all the numbers in the IP address assigned by your
network administrator
b) Press the
C) Set the Subnet Mask assigned by your network administrator if necessary:
/ N & R
ETUP ETWORK
IP A soft button.
ET DDRESS
and P keys to move the cursor in turn to each digit in the
EXT REV
soft button to confirm your setting.
S
AVE
.
/ N
EMOTE EXT
2-37
INSTALLATION