Connect The Net Mgt Cable - Sun Oracle NETRA SPARC T4-1 Installation Manual

Related Information
"SER MGT Port" on page 70
■
"Connect the NET MGT Cable" on page 75
■
"Connect Ethernet Network Cables" on page 76
■
"Connect Other Data Cables" on page 77
■

▼ Connect the NET MGT Cable

The service processor network management port is labeled NET MGT. After the
initial server configuration, you can connect to the service processor over an Ethernet
network using this NET MGT port. See
If your network uses a DHCP server to assign IP addresses, the DHCP server will
assign an IP address to this NET MGT port. With this IP address, you can connect to
the service processor using an SSH connection. If your network does not use DHCP,
this NET MGT port will not be accessible until you configure the network settings
through the SER MGT port. For instructions, see
SP" on page 88.
●
Connect a Category 5 (or better) cable from the NET MGT port to your network
switch or hub.
"NET MGT Port" on page
"Assign a Static IP Address to the
70.
Connecting Cables 75