Power On The Server For The First Time - Sun Oracle NETRA SPARC T4-1 Installation Manual

"SER MGT Port" on page 70
■
"Rear Panel Components" on page 6
■
"Power On the Server for the First Time" on page 85
■

▼ Power On the Server for the First Time

1. Confirm that you have installed the server in a rack and attached all of the data
cables.
See "Preparing for Installation" on page
"Connecting Cables" on page
2. Confirm that you made a serial connection to the SP.
See "Connect a Terminal or Emulator to the SER MGT Port" on page
Note – When you power on the server for the first time and you do not have a
terminal or terminal emulator (PC or workstation) connected to the SP SER MGT
port, you will not see system messages.
3. (Optional) Connect an Ethernet cable between the server's NET MGT port and
the network from which future connections to the SP and host will be made.
See "Connect the NET MGT Cable" on page
Note – After the initial configuration of the server using the SER MGT port,
communication with the SP and host is usually performed through this NET MGT
port.
4. Connect an Ethernet cable between one of the server's Gigabit Ethernet ports
and the network to which the server will communicate.
See "Connect Ethernet Network Cables" on page
5. Plug the power cords into the power supplies on the server.
6. Plug the power cords into the power source and close the circuit breakers.
19, "Installing the Server" on page
67.
75.
76.
Powering On the Server for the First Time
23, and
84.
85