Table of Contents
Advertisement
Caution – Do not use slide rail mounted equipment as a shelf or a work space.
Related Information
"Stabilize the Rack for Installation" on page 25
■
▼ Stabilize the Rack for Installation
Caution – To reduce the risk of personal injury, stabilize the expansion rack cabinet
and extend all antitilt devices before installing the server.
Refer to your rack documentation for detailed instructions for the following steps.
1. Open and remove the front and rear doors from the rack cabinet.
2. To prevent the rack cabinet from tipping during the installation, stabilize the
cabinet using all antitilt mechanisms provided.
3. If there are leveling feet beneath the rack cabinet to prevent it from rolling,
extend these leveling feet fully downward to the floor.
4. Fully extend the rack cabinet's antitilt legs or antitilt bar, which are located at
the bottom front of the rack cabinet.
Related Information
"Rack Cautions" on page 24
■
Documentation for your rack cabinet
■
Netra SPARC T4-1 Server Safety and Compliance Guide
■
Mounting the Server Into a 4-Post Rack
These topics provide installation instructions for the 4-post rackmount kits. The
server ships with a 19-inch, 4-post hardmount rackmount kit. You can order two
optional rackmount kits for your specific 4-post rack.
Installing the Server
25
Advertisement
Table of Contents
