2: Walk Test Loops Parameters - Honeywell nfs2-3030 Programming Manual

Walk Test
If this
parameter is
chosen...
PANEL
DEVICES
ZONE
DISABLE ACS BOARDS: This soft key allows the operator to disable ACS devices during Walk
Test. Press to toggle between the two choices, YES (disable) and NO (enable). Default: YES
4.6.2 Walk Test Loops Parameters
This screen appears when LOOPS is chosen as a parameter at the Walk Test Menu.
Once the START TEST soft key has been pressed and the
test begun, this message changes to ABORT
The chosen settings are displayed (BASIC, AUDIBLE in Figure 4.10), and installed loops will
display with a participation field. The up and down arrow keys on the keypad navigate through the
fields. Choose YES for participation, NO for no participation, using the
NEXT SELECTION
Soft Keys
START TEST: Press to begin Walk Test using the chosen parameters. Once Walk Test has begun,
this soft key becomes ABORT, and can be pressed at any time to exit Walk Test.
NFS2-3030 Programming Manual — P/N 52545:K1 03/20/2012
The participating devices/points in Basic
Test will be...
The entire panel - all devices/points set to
participate in Walk Test - will participate with
the exception of logic equations, whose
activation is suspended. When an input test
is initiated, only the outputs on the
corresponding loop will activate.
Individual detectors tested one at a time.
For BASIC Walktest only. When the zone
entered in the parameter field is present in a
device's first (primary) CBE location, that
device will go into Walk Test when the
parameter zone is put into Walk Test. When
an input test is initiated, outputs mapped to
the corresponding zone on all loops will
activate.
Table 4.1 Walk Test Parameters (2 of 2)
L A K E V I E W G E N E R A L H O S P I T A L
S Y S T E M N O R M A L
1 0 : 2 2 : 3 4 A T U E J A N 2 5 , 2 0 1 1
S E T T I N G S : B A S I C , A U D I B L E , L O O P S
L 1 : N O L 2 : N O
L 4 : N O L 5 : N O
L 7 : N O L 8 : N O
L 1 0 : N O
S T A R T T E S T
Figure 4.10 Walk Test Loops Programming Screen
(+)/ (-) keys on the keypad.
PREVIOUS SELECTION
The participating devices/points in
Advanced Test will be...
The entire panel - all devices/points set
to participate in Walk Test - will
participate. When an input test is
initiated, outputs mapped on all loops
will activate.
Detectors only.
n/a
W A L K T E S T
L 3 : Y E S
L 6 : Y E S
L 9 : Y E S
Alter Status
B A C K
79