1: Detector Point - Honeywell nfs2-3030 Programming Manual

Program
ACCEPT: Press to progress to the appropriate screen, based on the type of point selected.
NEXT/PREVIOUS SELECTION: Press to scroll backward or forward to the next or previously
installed point.
3.4.1 Detector Point
This screen displays when a detector is chosen at the POINT PROGRAM menu (see Figure 3.31 on
page 43).
Zone Map
position 1
(primary zone)
The point address is displayed in line 3 of this screen. Existing point information is displayed in the
fields.
Soft Keys
TYPE: Press this soft key to scroll through the point type choices: stop at the appropriate selection.
If a new point is being added, no other field will be displayed until TYPE: is entered and the
ACCEPT soft key is pressed. At this point, the rest of the fields will appear.
FLASHSCAN CODE LABEL: Press to scroll through a list of FlashScan
Codes. Stop when the appropriate label appears (Table G.4 on
page 142 for codes and descriptions). If the detector is not a
FlashScan type, choose NONE.
POINT LABEL: Press this soft key to place the cursor at this field. Type in a 20-character
maximum point label that will appear in message formats. If no entry is made, the field will default
to the point address.
EXTENDED LABEL: Press to place the cursor at this field. Type in a 12-character maximum
extended label to further define the location or nature of the point.
ZONE MAP: Displays the zones mapped to this point. During initial programming, zone map
position one for each detector is set to Z0YY, where YY represents the loop number where the
detector resides. In Figure 3.32 above, zone position one has a value of Z003 (YY = 03). The
detector in the example resides on loop 3.
To add or delete zones for this point, press this soft key to progress to the Detector Zone Map
screen.
MORE: Press this soft key to progress to the next detector point programming screen.
44
D E T E C T O R P O I N T P R O G R A M M I N G
T Y P E :
S M O K E ( P H O T O )
F L A S H S C A N T Y P E :
P O I N T L A B E L :
E X T E N D E D L A B E L :
Z O N E M A P :
Z 0 0 3 , Z 1 0 4 , Z 1 0 5 , Z 1 0 6 , Z 1 0 7 ,
Z 1 1 0 , Z 1 1 4 , Z 1 1 5 , Z 1 1 6 , Z 1 1 7
Zone Map position 6
Figure 3.32 Detector Point Programming Screen
NFS2-3030 Programming Manual — P/N 52545:K1 03/20/2012
L 0 3 D 1 2 3
P H O T O
A C C E P T
Zone Map position 10
Point Program
M O R E
B A C K