Honeywell nfs2-3030 Programming Manual page 46

Program
Soft Keys
ZONE MAP: A detector may be mapped to up to ten general, releasing, or special zones. There are
ten positions available for mapping; positions 1, 9 and 10 have additional functionality. (Refer to
Figure 3.33)
Position 1 - Use this position to link the 20-character zone label to the detector. The zone label
will appear after the 20-character label and 12-character extended label, providing a total of 52
characters to describe an event.
This position is checked when a group zone disable command is issued. If the zone number in
the group zone disable command matches the zone number in the first position of the zone
map, the detector point will be disabled.
Position 9 -
• Use this position to activate the sounder/relay base of a detector. When this position is
mapped to the same zone as Position 10, the sounder or relay base will be activated when
the detector goes into prealarm (Action).
• Use this position to activate the sounder base of a detector using a general or a logic zone.
When a general or logic zone activates, the panel is searched for any detector with the same
zone mapped in its 9th position. The sounder base of any FlashScan detector that matches
the search will activate.
Position 10 - Use this position to map detectors with an "Action" Prealarm setting. The zone in
the tenth position will activate when the detector reaches its Prealarm threshold; no other zones
in this detector's zone map will activate.
Move the cursor with the keyboard arrow keys to the appropriate zone map position, then select the
type of zone by pressing the
zone number to map the detector to it.
ACCEPT: Press to save entries made on this screen and return to the Detector Point Programming
screen.
Detector Point Programming (2)
Press the MORE soft key on the Detector Point Programming screen to display this screen.
46
NEXT SELECTION
D E T E C T O R P O I N T P R O G R A M M I N G
C U S T O M A C T I O N M E S S A G E : 0 1 0
A L A R M V E R I F I C A T I O N : O F F
L O C A L M O D E : O F F
W E E K L Y O C C U P A N C Y S C H E D U L E : 1 0
M U L T I - D E T E C T O R : D 1 0 0 , D 1 0 5
Figure 3.34 More Detector Point Programming (2) Screen
NFS2-3030 Programming Manual — P/N 52545:K1 03/20/2012
(+) key until the desired zone type appears. Type in a
L 0 3 D 1 2 3
S E N S I T I V I T Y
Point Program
M O R E
A C C E P T
B A C K