Daikin DCM601A51 Technical Data Manual page 83

ED721208
1.5.2 Part Names
1.5.3 Installation
COMPONENTS
Check the following components are included in this optional accessory before installation.
CONTROL BOARD BOX
Give to the customer this OPERATION MANUAL certainly.
INSTALLATION
Deside the situation of Control Board Box.
It is affected the situations of the thermistor.
The length of lead wire - Thermistor : 2.5m
Install the thermistor (in the control board box) at the inlet
duct or the suction grille.
Use the kit : remote sensor (KRCS01-1B), if you need the longer
length than it. (Can use it untill 12m.)
Install the control board box on the wall or the pillar.
Make sure the wire inlet is at the bottom of the box.
Use 4 bolts (M5) for fixing the box.
Install the box in the indoor side.
(Example : Set it in the ceiling or in the room.)
Do not install the box in the air conditioner.
Fixing situation : See below Fig. (Height : 125mm)
(*shows the fixing pich.)
1.5 Central Control Adaptor Kit <DTA107A55>
X2M X1M
OPERATION MANUAL INSTALLATION MANUAL WIRE HARNESS
Example : Set the thermistor into the
inlet duct and clamped by
resin clamp and fix plate.
410
*390
372
Adaptor
4
Unit (mm)
79