Adaptor
Restrictions in Continuous Installation
In case where several devices are set up and installation inside the power board is carried out, each
equipment installation space and space between the wall surface and this equipment should be left at
least as shown below.
(To Remove Front Panel: )
"1.4.4 Electric Wiring Work and Initial Setting" should be performed with the front panel removed.
The front panel can be removed by detaching 2 front panel screws shown in the figure above and sliding it
lightly to the upper side. Upon completion of all wiring connections and setting operations, close the front
panel as it was and screw it firmly.
128
DEC102A51
40
40
DEC102A51
140
Fix the DEC102A51
firmly with the installation
screws (M4)
DEC102A51
40
DEC102A51
ED721208
Unit (mm)
2.3 Dio Unit <DEC102A51>