Daikin DCM601A51 Technical Data Manual page 115

ED721208
<Setting Group No. for Centralized Control>
Set the group No. at the centralized control group No. setting switches (RS1 and RS2). Refer to the below table to set
group No. Group No. increases in the order of 1-00, 1-01 ... 1-15, 2-00, ... 4-15. Refer to the installation manual of the
centralized control equipment.
RS1 Switch Setting and Upper Group No. Position
Position
Group No.
RS2 Switch Setting and Lower Group No. Position
Position
Group No.
Make Settings before Turning ON the Power.
Note:
Group number need not be set on this adaptor during individual use with either a wiring adaptor for electrical appendices
or a schedule timer. Setting is automatic.
Ex. Setting group No. 1-15
First and second group No.s are indicated as below.
<Power Supply Wiring>
Power supply can be selected from a 1
specifications and properly wire the source to the adaptor.
Note:
Ground wires as shown in the figure on the above.
The adaptor may malfunction or be damaged if improperly wired.
The fuse is designed for short circuit protection (Overcurrent protection).
Therefore, it may not offer sufficient protection against improper voltage.
2.1 Wiring Adaptor for Other Air Conditioners <DTA103A51>
0 1 2
— 1 2
0 1 2 3 4
00 01 02 03 04
50 Hz 220-240V source and a 1
~
3 4 5
3 4 —
5 6 7 8 9
05 06 07 08 09
60 Hz 220V source. Check power supply
~
6 7 8
— — —
A B C D E
10 11 12 13 14
Adaptor
9
—
F
15
4
2PA53853
111