Installation Manual
1.3.3
1.3.4
12
198
Side face
On the left side face of the iTM integrator, a USB port cover is provided. You use this cover
during setup after installation or during maintenance. You also see an attached label,
bearing the model, weight, power ratings and the serial number of the iTM integrator.
[ ] Pulling up the rubber cover reveals a USB socket. This socket can be raised 90
degrees, so you can plug in a USB device to it from the front direction when there is no
clearance from the side edge of the unit.
Routing of cables
through the cable hole of the frame bracket.
An example of cables routed to the rear face of the iTM integrator is shown below.
A
To conduit tube
Make sure that each wiring is secured with supplied cable ties.
Secure the power supply cables to the blue resin cable mount with white cable ties and
secure them to the other wiring with black cable ties as shown on the wiring diagram
To secure the wiring with black cable ties, insert the cable tie head into the provided hole.
Installation Manual 3P291714-5
DCM601A53 iTM integrator
ED721208
A
English