Information List - Siemens SIPROTEC 7SD610 Manual

Functions
2.2 Protection Data Interfaces and Protection Data Topology
Addr. Parameter
4509 T-DATA DISTURB
4510 T-DATAFAIL
4511 PI1 SYNCMODE
4512 Td ResetRemote
4513A PROT1 max ERROR
4515A PI1 BLOCK UNSYM
4801 GPS-SYNC.
4803A TD GPS FAILD

2.2.3.3 Information List

No. Information
3215 Wrong Firmware
3217 PI1 Data reflec
3227 >PI1 light off
3229 PI1 Data fault
3230 PI1 Datafailure
3233 DT inconsistent
3234 DT unequal
3235 Par. different
3239 PI1 TD alarm
3243 PI1 with
3245 >GPS failure
3247 GPS loss
3248 PI 1 GPS sync.
3250 PI 1 PD unsym.
3252 >SYNC PI1 RESET
3254 PI1 jump
3256 PI1 unsym.
3258 PI1 Error
3274 PI1: C37.94 n/a
62
Setting Options
0.05 .. 2.00 sec
0.0 .. 60.0 sec
TEL and GPS
TEL or GPS
GPS SYNC OFF
0.00 .. 300.00 sec; ∞
0.5 .. 20.0 %
YES
NO
ON
OFF
0.5 .. 60.0 sec
Type of In-
formation
OUT Incompatible Firmware Versions
OUT Prot Int 1: Own Datas received
SP >Prot Int 1: Transmitter is switched off
OUT Prot Int 1: Reception of faulty data
OUT Prot Int 1: Total receiption failure
OUT Device table has inconsistent numbers
OUT Device tables are unequal
OUT Differences between common parameters
OUT Prot Int 1: Transmission delay too high
VI Prot Int 1: Connected with relay ID
SP > GPS failure from external
OUT GPS: local pulse loss
OUT GPS: Prot Int 1 is GPS sychronized
OUT GPS:PI1 unsym.propagation delay too high
SP > PI1 Synchronization RESET
OUT Prot.1: Delay time change recognized
IntSP Prot.1: Delay time unsymmetry to large
OUT ProtInt1:Permissible error rate exceeded
OUT PI1: IEEE C37.94 not supported by module
Default Setting
0.10 sec Time delay for data disturbance
alarm
6.0 sec Time del for transmission failure
alarm
TEL and GPS PI1 Synchronizationmode
0.00 sec Remote signal RESET DELAY for
comm.fail
1.0 % Prot 1: Maximal permissible error
rate
YES Prot.1: Block. due to unsym. delay
time
OFF GPS synchronization
2.1 sec Delay time for local GPS-pulse
loss
Comments
C53000-G1176-C145-6, Release date 02.2011
Comments
SIPROTEC, 7SD610, Manual