Information List; Device; Trip-Dependent Indications - Siemens SIPROTEC 7SD610 Manual

2.16.2.2 Information List

No. Information
- CB1tst L1
- CB1tst L2
- CB1tst L3
- CB1tst 123
7325 CB1-TESTtrip L1
7326 CB1-TESTtrip L2
7327 CB1-TESTtrip L3
7328 CB1-TESTtrip123
7329 CB1-TEST close
7345 CB-TEST running
7346 CB-TSTstop FLT.
7347 CB-TSTstop OPEN
7348 CB-TSTstop NOTr
7349 CB-TSTstop CLOS
7350 CB-TST .OK.
2.16.3

Device

The device requires some general information. This may be, for example, the type of indication to be issued in
the event a power system fault occurs.

2.16.3.1 Trip-Dependent Indications

Spontaneous fault indications
After a fault, the essential fault data spontaneously appear on the device display. Under address 610
FltDisp.LED/LCD you can select whether the spontaneous fault indications are updated in every case of
fault (Target on PU) or only in faults with tripping (Target on TRIP).
Figure 2-110
SIPROTEC, 7SD610, Manual
C53000-G1176-C145-6, Release date 02.2011
Type of In-
formation
-
-
-
-
OUT
OUT
OUT
OUT
OUT
OUT
OUT_Ev
OUT_Ev
OUT_Ev
OUT_Ev
OUT_Ev
Generation of spontaneous fault indications on the display
2.16 Function Control and Circuit Breaker Test
Comments
CB1-TEST trip/close - Only L1
CB1-TEST trip/close - Only L2
CB1-TEST trip/close - Only L3
CB1-TEST trip/close Phases L123
CB1-TEST TRIP command - Only L1
CB1-TEST TRIP command - Only L2
CB1-TEST TRIP command - Only L3
CB1-TEST TRIP command L123
CB1-TEST CLOSE command
CB-TEST is in progress
CB-TEST canceled due to Power Sys. Fault
CB-TEST canceled due to CB already OPEN
CB-TEST canceled due to CB was NOT READY
CB-TEST canceled due to CB stayed CLOSED
CB-TEST was successful
Functions
237