Operating Using Keypad - LG SV-iS5 Instruction Manual

Chapter 4 – Quick start procedures

4.1 Operating using keypad

1. Apply AC power.
2. LCD: Press [? key three times.
]
7-Seg: Rotate the encoder knob until
' 03' is displayed.
3. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
4. LCD: Press [? ] key one time.
7-Seg: Rotate the encoder knob left.
5. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
6. Press [PROG/ENT] key.
7. LCD: Press [PROG] key.
7-Seg: Press [PROG/ENT] key.
8. LCD: Press [SHIFT/ESC] key and
press [? key to increase the
]
command frequency.
7-Seg: Rotate the encoder knob right
to change the command frequency.
The changing digit moves by pressing
the SHIFT/ESC] key.
[
9. LCD: Press [ENT] key to save the
data.
7-Seg: Press [PROG/ENT] key to
save the data.
10. LCD: Press [FWD] or [REV] key to
start motor.
7-Seg: Press [RUN] key to start
motor.
11. Press [STOP/RESET] key to stop
motor.
Morek IT OÜ, Rauna 24, 76506 Saue Harjumaa, Estonia. www.morek.eu Tel. +372 604 1423 Fax +372 604 1447 morek@morek.eu
LCD Display
DRV?T/K 0.0 A
00 STP 0.00Hz
DRV? Drive mode
03 Fx/Rx-1
DRV? Drive mode
03 Fx/Rx-1
DRV? Drive mode
03 Keypad
DRV? Drive mode
03 Keypad
DRV?K/K 0.0 A
00 STP 0.00Hz
DRV? Cmd. freq
00 0.00Hz
DRV? Cmd. freq
00 60.00Hz
DRV?K/K 0.0 A
00 STP 60.00Hz
The FWD or REV LED starts blinking.
The STOP/RESET LED starts blinking.
52
7-Segment Display
The DRV LED is ON.
The DRV LED is turned ON.
The PROG/ENT LED turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The RUN LED starts blinking.
To change the motor running
direction, change DRV 13 to ' 1' .
The STOP/RESET LED starts blinking.