Chapter 4 Performance Specification 4-1~4-33; Operating Mode Setting - LG GLOFA-GM Series User Manual

Chapter 4 Performance specification
Chapter 4 Performance specification
4.1 Operation mode setting
The operation mode of this module is set with operation mode switch on the front, and interlocking/stand-alone mode or
operation mode for each channel is determined according to the operation mode. Setting method of operation mode is
after selecting required mode adjusting switch values of operation mode with power off, set by power on. Operation
mode is unchangeable even if switch values of operation mode are changed during operation, so surely after power off,
change the switch values. [Table4.1] & [Table4.2] describe the operation modes according to switch values.
[Table4.1] Operation mode of G3L-CUEA/G4L-CUEA
Switch type
8
7
9
6
5 0
4 1
3 2
Applicable module
(G3L-CUEA/G4L-CUEA)
[Table4.2] Operation mode of G6L-CUEB/G6L-CUEC
Switch type
8
7
9
6
5 0
4 1
3 2
Applicable module
(G6L-CUEB/CUEC)
Switch value
of operation
RS-232C
mode
0 User defined communication
1 Dedicated communication
2 User defined communication
3 Dedicated communication
4 User defined communication
5 Dedicated communication
6 GMWIN
7 GMWIN
Loop-Back
8
Flash writing mode
9
Switch value
of operation
mode
0 User defined communication
1 Dedicated communication
2 GMWIN service
3
4 ~ 7
8
9
Operation mode
RS-422
User defined communication
Dedicated communication
User defined communication
Dedicated communication
Dedicated communication
User defined communication
User defined communication
Dedicated communication
Loop-Back
Ver. 2.0
[Note4]
On-line mode Ver. 2.0 [Note5]
Operation mode
Off-line
Loop-Back
Not used
Flash writing mode
Ver. 2.0
On-line mode Ver. 2.0
4-1
Remark
Off-line
mode
[Note3]
Self-diagnosis mode
Remark
G6L-CUEC doesn't support
mode
GMWIN service (supports
only G6L-CUEB)
Not used in Ver.1.0
Interlocking
mode
[Note1]
Stand-alone
mode
[Note2]
[Note6]