7-Segment Keypad - LG SV-iS5 Instruction Manual

Chapter 2 - Operation

2.3 7-Segment Keypad

7-segment display
Encoder knob
Used to move you
through parameter
groups and parameter
code. Also, used to
change data by rotating
knob.
Program Button is used
to go into programming
mode to change data.
Enter Button is used to
enter the changed data.
The LED blinks during
programming mode.
* Parameter Group Display LEDs – When parameter code is located on DRV 20, DRV 21, DRV 22 and DRV 23, respectively by
rotating the encoder knob, the parameter group display LEDs of DRV, FUN1, FUN2, I/O, EXT blink.
LED Parameter Group
DRV Drive Group
FU1 FUNCTION 1 Group
FU2 FUNCTION 2 Group
I/O Input/ Output Group
EXT Sub-Board Group
I/O + EXT Option Group
FU2 + I/O + EXT Application Group
Morek IT OÜ, Rauna 24, 76506 Saue Harjumaa, Estonia. www.morek.eu Tel. +372 604 1423 Fax +372 604 1447 morek@morek.eu
Lit in Drive group.
Blinks when the parameter code is located on DRV 20 [FUN1].
Lit when FUNCTION 1 group is selected.
Blinks when the parameter code is located on DRV 21 [FUN2].
Lit when FUNCTION 2 group is selected.
Blinks when the parameter code is located on DRV 22 [I/O].
Lit when Input/Output group is selected.
Blinks when the parameter code is located on DRV 23 [EXT].
Lit when Sub-Board group is selected.
This group appears only when a Sub-Board is installed.
Blinks when the parameter code is located on DRV 24 [EXT].
Lit when Option group is selected.
This group appears only when an Option Board is installed.
Blinks when the parameter code is located on DRV 25 [FUN2].
28
* Parameter Group
Display LEDs.
[SHIFT] This button is
used to move cursor
across display in
programming mode.
[ESC] This button is used
to move the program
code to DRV 00 from any
program code.
Run Button is used to
run the drive. The motor
direction is set in DRV
13.
The Run LED blinks
when the drive Accels or
Decels.
Stop Button is used to
stop the drive from
running.
Reset Button is used to
reset Faults.
The LED blinks when
there is a fault.
Description