Dial Up; General Options; Training Mode - Ingenico iCT250 Merchant Manual

a) S elect the desired option (1- Terminal IP, 2- Gateway IP, 3- IP SubMask, 4- Primary DNS IP or 5-
Secondary DNS IP).
b) W hen you select any of the above options, enter the IP address
you must complete all of the above information.
A ll of the addresses are 12 digits long and supplied by your Internet service provider (ISP). Leading zeros are
not usually provided or required to be entered. It is four groups of 1 to 3 numbers separated by decimal points.
Please ensure that you enter the decimal points in your IP addresses as they do not auto-populate.
5.
The IP address is now saved.

Dial up

Use this option to change the dial up communications setting.
1. Press / Admin key  Setup Menu  Communications  Dial
. , # *
2.
S elect the desired option (1 - Prefix Code or 2 - LD Prefix or 3 – Pre-Dial or 4 - Dial Retry or 5 – DialTone 6
– Baud or 7 – Dial Mode).
» P refix
OK. For example, some office buildings may require you press 9
» L D Prefix – Enter the long distance prefix code that may be required and press OK.
» Predial – Select whether it is On or Off. Setting it to On will reduce the time it takes to perform the
transaction.
» Dial Retry – enter how many times that you want to retry dialing the server if you don't connect on
the first time and press OK. Do not set this higher than 3.
» Dial Tone
» Baud – Select which baud rate you want to use to connect to the server (1 – 300, 2 – 1200 or 3
– 2400) and press OK. Select 3
» Dial Mode – Select which mode you want to use (1 – Tone or 2 – Pulse).
3.
The new dial up communication method is now active.
General options
Use these options to configure your terminal's volume, screen brightness and other general settings.

Training mode

This option allows a Manager or Supervisor to sign in and train a new user on the functions of the terminal without
impacting any live transactions or totals. While in Training Mode the user can perform all transactions except for any
configuration changes or chip card transactions. When in training mode:
• The Idle screen will display the word Training.
• All screen names will have a (D) at the end to indicate that you are in demo/training mode – Sale (D), Main Menu (D), etc.
• You can create, edit and delete users that will be active after you exit training mode.
• Receipts will include **** Training Mode **** under the transaction type.
1. Press / Admin key  Other Functions  Training Mode.
. , # *
2.
Enter or exit training mode (1 - Enter or 2 - Exit).
3. T raining mode is now enabled/disabled depending upon your selection. You will return to the Idle screen with
the word Training.
Code – Enter the prefix code that may be required to access the telephone network and press
Check – Select whether it is On or Off.
- 2400.
Menu.
- 24 -
and press OK. For a static IP address
before dialing out of the building.