Selected Channel View Screen - Yamaha CL1 Reference Manual

SELECTED CHANNEL VIEW screen

■ SEND field
In this field, you can view the send level from the channel to each MIX/
MATRIX bus, switch the on/off status of the send signals, and switch between
pre and post.
1
Tabs
Enable you to select a group of 16 output bus channels to be displayed
in the SEND field.
• MIX1–16 tab.............................. displays MIX buses 1–16.
• MIX17–24/MATRIX tab ......... displays MIX buses 17–24 and
MATRIX buses 1–8.
The view and the function of the knobs and buttons in the SEND field vary
depending on whether a pair of bus channels (odd-numbered and even-
numbered) are comprised of two mono channels or a stereo channel.
If the destination bus channels are two mono channels:
1
2
3
1
SEND knob
Sets the send level to the corresponding bus.
2
PRE indicator
Indicates the send point of the corresponding bus. If the PRE button on the MIX SEND 8ch screen
is turned ON, this PRE indicator will be turned on.
3
ON button
Switches the send signal to the corresponding bus on or off.
If the destination bus is a stereo channel:
1
1
SEND/PAN knob
The right-hand knob adjusts the level of the signal sent to a pair of bus channels (even-numbered
and odd-numbered). The left-hand knob adjusts the pan and balance of the same signal.
2
PRE indicator
Indicates the send point of the corresponding bus. If the PRE button on the MIX SEND 8ch screen
is turned ON, this PRE indicator will be turned on.
3
ON button
Press the right-hand button to switch on or off the signal sent to two bus channels.
NOTE
• If the indices of a SEND/PAN knob are white, the send point is assigned as PRE; if the indices
are black, it is assigned as POST.
• If the send point is PRE, you can specify the PRE point as either VARI [PRE EQ] or VARI [PRE
FADER] in the BUS SETUP popup that appears when you press the SETUP button → BUS
SETUP button.
• If the type of the destination bus is set to FIXED, controllers
displayed. The send level will be fixed at nominal level, and the send point will be fixed at POST
FADER. For details, see
• Press the SEND LEVEL knob or PAN knob on screen to open the SEND 8ch popup window.
7
1
2
3
"Basic settings for MIX buses and MATRIX
SELECTED CHANNEL section
1 2
– mentioned above will not be
buses" on page 202.
Reference Manual