Yamaha CL1 Reference Manual page 214

3.
In the upper part of the DANTE SETUP popup screen, press the SETUP tab to access
the SETUP field.
1
3
7
This screen contains the following items.
1
CONSOLE ID select buttons
Set the IDs for the CL series consoles.
If five or more CL units are connected to a network, and you plan not to assign IDs to some of the
units, press the OFF button of each of those units to turn off the ID.
2
SECONDARY PORT select buttons
Specify how the Dante audio network is configured.
3
CANCEL button
When editing the CONSOLE ID or SECONDARY PORT settings, you can press this button to
cancel the changes you made.
4
APPLY button
After changing the CONSOLE ID or SECONDARY PORT settings, press this button to apply the
changes you made.
5
BIT select buttons
Enable you to set the audio bit depth to 24-bit or 32-bit.
NOTE
24bit: Use this when transmitting and receiving data to or from an Rio unit. When using a CL
series system, you will normally use this setting.
32bit: This is effective when transmitting and receiving 25-bit or larger data (when using cascade
or gain compensation), but the amount of data being transmitted will increase 20–30% compared
2
to 24-bit.
6
LATENCY select buttons
Enable you to set the Dante audio network latency to 0.25 ms, 0.5 ms, 1.0 ms, or 5.0 ms.
The latency setting varies depending on the network connection method and size. For details,
4
refer to
5
7
DANTE PATCH BY select buttons
Use these select buttons when using Dante Controller to make Dante patch settings.
6
If the THIS CONSOLE button is selected, the DANTE INPUT PATCH and DANTE OUTPUT
PATCH settings can be edited from the CL series console.
If the DANTE CONTROLLER button is selected, it will not be possible to edit the Dante patch
settings.
You can operate these buttons regardless of the state of the DANTE PATCH BY select buttons on
other CL series consoles on the network.
NOTE
• Settings that are shared with the I/O device (BIT/LATENCY/W.CLOCK) will reflect the settings of
the CL series console whose CONSOLE ID is set to #1.
• If the DANTE CONTROLLER button is selected in the DANTE PATCH BY section, and you
attempt to edit the Dante patching or related settings, the message "This Operation is Not
Allowed" will appear at the bottom of the screen.
214
"Setting the Dante audio network latency" on
Other functions
page 215.
Reference Manual