To Stereo/Mono - Yamaha CL1 Reference Manual

TO STEREO/MONO popup window (8ch)
You can control the on/off and pan/balance settings of the signal sent from MIX channels to the
STEREO (L/R) bus and MONO (C) bus, in groups of eight channels.
1
2
3
4
5
6
1
Channel select button
Selects the channel. You can select multiple channels simultaneously.
2
Mode LEDs
3
MODE (ST/MONO/LCR mode select) button
Press this button repeatedly to toggle between ST/MONO and LCR. The LED of the currently-
selected mode will light.
4
ST/MONO buttons
These buttons are individual on/off switches for signals that are sent from each channel to the
STEREO bus/MONO bus when the MONO button is set to ST/MONO mode.
5 Σ clipping indicator
Lights to indicate a signal is clipping at some point in the channel.
6
TO ST PAN/TO ST BALANCE knob
If the type of the MIX channel signal is MONO, this knob will function as a PAN knob that adjusts
the left and right pan position of the signal sent to the STEREO bus. If the type of MIX channel
signal is STEREO, this knob will function as a BALANCE knob that adjusts the volume level
balance of left and right signals sent to the STEREO bus. To adjust the value, press the knob to
select it, and then operate the corresponding multifunction knob.
If the ST/MONO/LCR mode select button is set to LCR mode, the following button and knob are
displayed instead of the ST/MONO button (
7
8
7
LCR button
This button is an overall on/off button for signals sent from a channel to the STEREO bus and
MONO bus. If this button is off, no signals will be sent from the corresponding input channel to
the STEREO bus or MONO bus.
8
CSR knob
Adjusts the relative level of signals sent from the channel to the STEREO (L/R) bus and to the
MONO (C) bus, in the range of 0–100%. To adjust the value, press the knob to select it, and then
operate the corresponding multifunction knob.
49
4
).
Output channels
Reference Manual