Sending A Signal From An Input Channel To A Mix/Matrix Bus - Yamaha CL1 Reference Manual

If the CSR knob is set to 100%, operating the INPUT TO ST PAN knob will change the level of
signals sent to the STEREO (L/R) bus and MONO (C) bus, as shown in the following diagram.
L C R
PAN knob
Operating the TO ST BALANCE knob of an ST IN channel will change the level of signals sent
from the STEREO L/R channels to the STEREO (L/R) bus and MONO (C) bus, as shown in the
following diagram.
L C R
TO ST BALANCE knob
Signal sent from the ST IN (R) channel to
the MONO (C) bus
Signal sent from the ST IN (R) channel to
the STEREO (R) bus
L C R
TO ST BALANCE knob
Signal sent to the MONO (C) bus
Signal sent to the STEREO (L) bus
Signal sent to the STEREO (R) bus
Signal sent from the ST IN (L) channel to
the MONO (C) bus
Signal sent from the ST IN (L) channel to
the STEREO (L) bus
Sending a signal from an input channel to a MIX/
MATRIX bus
This section explains how to send a signal from an input channel to MIX buses 1–24 and MATRIX
buses 1–8.
The MIX buses are used mainly for the purpose of sending signals to foldback speakers on stage, or to
effect processors. The MATRIX buses are used to produce a mix that is independent of the STEREO
bus or MIX buses, and is typically sent to a master recorder or to a backstage monitoring system.
You can send a signal from an input channel to a MIX/MATRIX bus in the following three ways.
■ Using the SELECTED CHANNEL section
With this method, you use the knobs in the SELECTED CHANNEL section to adjust the send levels to
the MIX/MATRIX buses. When using this method, signals sent from a specific input channel to all
MIX/MATRIX buses can be adjusted collectively.
■ Using the Centralogic section
With this method, you use the multifunction knobs in the Centralogic section to adjust the level of
signals sent to the MIX/MATRIX buses. When using this method, the signals sent from eight
consecutive input channels to a specific MIX/MATRIX bus can be adjusted simultaneously.
■ Using the faders (SENDS ON FADER mode)
With this method, you switch the CL series unit to SENDS ON FADER mode, and use the faders on the
top panel to adjust the level of signals sent to the MIX/MATRIX buses. When using this method, signals
sent from all input channels to a specific MIX/MATRIX bus can be adjusted simultaneously.
Using the SELECTED CHANNEL section
This section explains how to use the knobs in the SELECTED CHANNEL section to adjust the send
levels of signals sent from a specific input channel to all MIX/MATRIX buses.
1.
Make sure that an output port is assigned to each MIX/MATRIX bus to which you
want to send signals, and that your monitor system, external effect processor, or
other device is connected to the corresponding output port.
2.
Use the [SEL] keys on the top panel to select the input channels that will send
signals to the MIX/MATRIX buses.
39
Input channels
Reference Manual