Meter - Yamaha CL1 Reference Manual

3
ASSIGN section
Enables you to select a channel to which the oscillator signal will be sent. Press one of the three
tabs located at the bottom of the screen, then press the button(s) for the channel(s) in this section
(multiple selections are allowed). The "ASSIGNED" indicator is lit green for a tab that contains a
selection.
You can press the CLEAR ALL button to defeat all selections.
NOTE
In the case of the CL3/CL1, channels that do not exist on those models will not be shown.
4
Meter section
Indicates the oscillator output level.
5
OSCILLATOR OUTPUT button
Turns the oscillator on or off.
3.
Press a button in the MODE field to select the type of signal you want to output.
4.
Use the knobs and buttons in the parameter field to adjust the oscillator
parameters.
The displayed parameters will differ depending on the oscillator selected in the MODE field. The
knobs shown in the parameter field can be operated using the corresponding multifunction
knobs.
5.
Press a button in the ASSIGN field to specify the input channel(s) or bus(es) to
which the oscillator signal will be sent (multiple selections are allowed).
6.
To enable the oscillator, press the OUTPUT button to turn it on.
The oscillator signal will be sent to the input channel or bus you selected in step 5. When you press
the button again, the oscillator will turn off.
110
Talkback and Oscillator
Reference Manual