Selected Channel View Screen - Yamaha CL5 Reference Manual

SELECTED CHANNEL VIEW screen

SEND field
In this field, you can view the send level from the channel to each MIX/
MATRIX bus, switch the on/off status of the send signals, and switch between
pre and post.
1
Tabs
Enable you to select a group of 16 output bus channels to be displayed
in the SEND field.
• MIX1–16 tab.............................. displays MIX buses 1–16.
• MIX17–24/MATRIX tab ......... displays MIX buses 17–24 and
MATRIX buses 1–8.
The view and the function of the knobs and buttons in the SEND field vary
depending on whether a pair of bus channels (odd-numbered and even-
numbered) are comprised of two mono channels or a stereo channel.
If the destination bus channels are two mono channels:
1
2
3
1
SEND knob
Sets the send level to the corresponding bus.
2
PRE indicator
Indicates the type of the corresponding bus. If the type is VARI [PRE EQ] or VARI [PRE FADER],
and if the PRE button on the MIX SEND 8ch screen is turned ON, this PRE indicator will be
turned on.
3
ON button
Switches the send signal to the corresponding bus on or off.
If the destination bus is a stereo channel:
1
1
SEND/PAN knob
The right-hand knob adjusts the level of the signal sent to a pair of bus channels (even-numbered
and odd-numbered). The left-hand knob adjusts the pan and balance of the same signal.
2
PRE indicator
Indicates the type of the corresponding bus.
3
ON button
Press the right-hand button to switch on or off the signal sent to two bus channels.
NOTE
• If the type of the destination bus is set to FIXED, controllers
displayed.
• Press the SEND LEVEL knob or PAN knob on screen to open the SEND 8ch popup window.
7
1
2
3
SELECTED CHANNEL section
2 3
– mentioned above will not be
Reference Manual