Setting The Network Address - Yamaha CL1 Reference Manual

Setting the network address

This section explains how to set the network address that will be required when you use the
NETWORK connector on the CL series console to connect it to a computer.
NOTE
Only the Administrator can change network settings.
1.
In the Function Access Area, press the SETUP button to access the SETUP screen.
2.
In the center of the SETUP screen, press the NETWORK button to access the
NETWORK popup window.
1
2
1
IP ADDRESS
Specifies an address that identifies an individual device on the Internet or LAN network.
2
GATEWAY ADDRESS
Specifies an address that identifies a device (gateway) that converts data between different media
or protocols to allow communication within the network.
3
SUBNET MASK
Within the IP address used in the network, this defines the bits that are used for the network
address that distinguishes the network.
4
MAC ADDRESS
Indicates the MAC (Machine Access Control) address, which identifies a host in a network. This
address is for display only, and cannot be edited.
NOTE
The NETWORK connector on the CL series console transmits data via either 100BASE-TX
(transmission speed: maximum 100 Mbps) or 10BASE-T (transmission speed: max 10 Mbps).
3.
Press the on-screen knob or the multifunction knobs on the top panel to specify
the address.
If you plan to connect the CL series console to your computer in a one-to-one connection, we
recommend that you use the following default values. Make sure that the IP address and Gateway
address do not match the addresses of any other device on the network.
IP address:
Gateway address: 192.168.0.1 or similar
Subnet mask:
For details on settings related to connecting to a LAN, refer to the CL Editor Installation Guide.
4.
When you have finished making settings, press the OK button.
If you changed the setting, a confirmation dialog box will appear.
3
4
5.
To make the setting, press the OK button.
The changes will be finalized, and the popup screen will close. If you decide to cancel the change,
press the CANCEL button instead of the OK button.
NOTE
In order for the change to take effect, you must power-off the CL series console and then turn it
on again.
6.
Restart the CL series console.
205
192.168.0.128 or similar
255.255.255.0 or similar
Other functions
Reference Manual