Basic Settings For Mix Buses And Matrix Buses - Yamaha CL1 Reference Manual

Operations on the cascade master CL unit
1.
In the Function Access Area, press the SETUP button to access the SETUP screen.
2.
In the SYSTEM SETUP field located in the center of the SETUP screen, press the
CASCADE button to open the CASCADE popup window.
3.
Press the CASCADE IN PATCH tab to access the CASCADE IN PATCH page.
4.
Press the port select popup button for the bus to which you want to assign a port.
The PORT SELECT popup window will appear.
5.
Use the category select list and port select buttons to select the desired slot and
input ports, and then press the CLOSE button.
The port will be assigned to the selected bus.
6.
Repeat steps 4 and 5 to assign ports to other buses.
If desired, you can assign two or more buses to the same input port.
7.
If you want to link specific parameters or events between two CL series consoles,
proceed as follows.
7–1. Use the CASCADE COMM PORT field to select the port that will transmit and
receive control signals for cascade link.
The items you can select are the same as in the CASCADE OUT PATCH popup window
(see page 200).
NOTE
Control signals for the cascade link and MIDI messages cannot share the same port. If you select
a port that is already specified for transmission/reception of MIDI messages, a dialog box will ask
whether it is OK to cancel the existing settings.
7–2. Use the CASCADE LINK MODE buttons to select the item that you want to link.
The items you can select are the same as in the CASCADE OUT PATCH popup window
(see page 200).
8.
To close the CASCADE popup window, press the CLOSE button.
In this state, the bus signals of the cascade slave will be sent via the slot to the buses of the cascade
master, and the combined signals of both buses will be output from the cascade master. If the
Cascade Link function is enabled, the specified operations or parameter changes performed on
either CL series console will be followed by the other CL console.

Basic settings for MIX buses and MATRIX buses

This section explains how to change the basic settings for MIX buses and MATRIX buses, such as
switching between stereo and monaural, and selecting the send point from which the signal of an input
channel will be sent.
The settings you make in the following procedure will be saved as part of the scene.
1.
In the Function Access Area, press the SETUP button to access the SETUP screen.
2.
In the center right of the SETUP screen, press the BUS SETUP button to open the
BUS SETUP popup window.
In the BUS SETUP popup window you can make various settings for MIX buses and MATRIX
buses.
1 2
MIX 1–16 page
1
SIGNAL TYPE switch buttons
Select how signals are processed for every adjacent pair of buses. Select either STEREO (stereo
signal) or MONOx2 (monaural signal x 2).
2
Bus type/send point select buttons (MIX bus only)
For every adjacent pair of buses, you can select the bus type and (for vari-type) the send point.
These buttons correspond to the following parameters.
Button
VARI [PRE EQ] VARI
VARI [PRE FADER] VARI
FIXED FIXED
202
4 1
MIX BUS 17–24/MATRIX BUS page
Bus type Pre-fader send point
Immediately before the EQ
Immediately before the fader
---
Other functions
3 4
Reference Manual