Setup - Yamaha CL1 Reference Manual

3
DANTE SETUP button
Press this button to open the DANTE SETUP popup window, in which you can make settings for
the audio network.
■ HA display
This shows the HA settings of the I/O device. Press this area to open the I/O DEVICE HA popup
window, in which you can make detailed head amp settings.
6
5
4
7
4
Analog gain knob
Indicates the analog gain setting. This item is only for display, and cannot be edited.
5
+48V indicator
Indicates the phantom power (+48V) on/off status for each port.
6
OVER indicator
Warns you when the input signal is clipping.
7
HPF indicator
Indicates the high pass filter on or off status for each port.
■ INPUT display
This shows the input settings of the I/O device.
If you press the [SEL] key of an input channel, the corresponding port will light.
■ OUTPUT display
This shows the output settings of the I/O device. Press here to access the OUTPUT PATCH popup
window, where you can make output port settings for the I/O device.
If you press the [SEL] key of an output channel, the corresponding port will light.
2.
To remotely control the head amp of an I/O device, press the I/O device in the HA
display.
The I/O DEVICE HA popup window will appear. In this window, you can remotely control the
head amp on the I/O device from the CL series console by using the on-screen knobs and buttons
or the multifunction knobs on the top panel.
2
3
4
5
6
1
+48V MASTER
Indicates the on/off status of the I/O device's master phantom power. (Switching this on or off is
performed on the I/O device itself.)
2
+48V button
Switch phantom power on or off for each channel.
3
GAIN knob
Indicates the gain of the head amp on the I/O device. To adjust the value, press the knob to select
it, and use multifunction knobs 1–8. The level meter located immediately to the right of the knob
shows the input level of the corresponding port.
4
GC button
Switches on or off the Gain Compensation function that maintains a consistent signal level on the
audio network.
5
FREQUENCY knob/HPF button
These controllers switch on or off the high-pass filter built into the head amp of the I/O unit, and
adjust its cutoff frequency. If you press the FREQUENCY knob to select it, you will be able to
adjust it using the corresponding multifunction knob.
6
Displayed port switch tabs
These tabs switch the port that is displayed in the I/O DEVICE HA popup window.
7
GC ALL ON button/GC ALL OFF button
Switch Gain Compensation on or off for all input channels simultaneously.
141
I/O device and external head amp
7
1
Reference Manual