Using Mute Groups; Controlling Dca Groups; Assigning Channels To Mute Groups - Yamaha CL1 Reference Manual

Controlling DCA groups

Use the faders in the Centralogic section to control DCA groups.
1.
Assign input channels to DCA groups.
2.
Using the faders in the Channel Strip section or Master section on the top panel,
adjust the relative balance between the input channels that belong to the DCA
group you want to use.
3.
In the Centralogic section, press the [DCA 1–8] or [DCA 9–16] Bank Select key to
make it light so that you will be able to control the desired DCA groups in the
Centralogic section.
4.
Operate the Centralogic section fader corresponding to the DCA group that you
want to use.
The level of the channels assigned to that DCA group will change while preserving the level
differences you established in step 2.
NOTE
Operating a DCA fader will not cause the input faders to move in tandem.
5.
To switch a DCA group on/mute, press the [ON] key for that DCA group in the
Centralogic section.
When you press an [ON] key in the Centralogic section to make the key indicator go dark, the
channels assigned to that DCA group will be muted (the same state as when the faders are lowered
to the –∞ dB position).
6.
To cue-monitor a DCA group, press the [CUE] key for that DCA group in the
Centralogic section.
When you press the [CUE] key in the Centralogic section to make the key indicator light, the
[CUE] keys for the channels assigned to that DCA group will blink, and cue monitoring will be
enabled. For more information about cue, refer to
NOTE
You can also press the [DCA], [DCA 1–8], or [DCA 9–16] key in the Channel Strip section to select
the DCA group that you want to control.
"Using the Cue function" on page 101.

Using mute groups

This section explains how to assign channels to mute groups and use the USER DEFINED keys to
control them.

Assigning channels to mute groups

As with the DCA group, there are the following two ways to assign channels to mute groups.
• You can select a specific mute group first and then specify the channels to be assigned to the group, or
• You can select a specific channel and then specify the mute group to which it should be assigned.
■ Selecting the channels that will belong to a specific mute group
1.
In the Function Access Area, press the CH JOB
button.
The Function Access Area will change as follows.
2.
Press the MUTE GROUP button to access the
DCA/MUTE GROUP ASSIGN MODE popup
window.
66
Grouping and linking
MUTE GROUP button
Reference Manual