Yamaha CL1 Reference Manual page 117

4.
Use the MODULE SELECT buttons to select the item you want to mount, and press
the OK button.
5.
To select the input source for a rack, press the INPUT PATCH button for that rack.
The CH SELECT popup window will appear, allowing you to select the input source for the rack.
Switch the list as necessary, and select the input source channel that you want to patch.
When you select an input source in the CH SELECT popup window, a dialog box will ask you for
confirmation. To confirm the operation, press the OK button.
NOTE
• You have the option of making settings so that the confirmation dialog box will not appear
(see page 169).
• Normally you can specify two channels of input for each rack. However if you have selected
31BandGEQ, only one channel can be used.
1 3
1
Category select list
Selects the category of channel shown in the popup window.
• MIX/MATRIX.................................. MIX 1–24, MATRIX 1–8
• ST/MONO......................................... STEREO L/R, MONO
• INSERT OUT 1–32.......................... CH 1–32
• INSERT OUT 33–64 ....................... CH 33–64
• INSERT OUT 65–72 ....................... CH 65–72
• INSERT OUT MIX/MATRIX ....... MIX 1–24, MATRIX 1–8
• INSERT OUT ST/MONO .............. STEREO L/R, MONO
*1. Not displayed for GEQ 1–16 RACK.
*2. Not displayed for PREMIUM 3–8 RACK. Displayed only for PREMIUM 1–2 RACK.
NOTE
In the case of the CL3/CL1, channels that do not exist on those models will not be shown.
2
*1, *2
*1, *2
*1
*1
*1
2
Channel select buttons
Use these buttons to select the input source channel.
3
CLOSE button
Closes the popup window.
NOTE
In the case of the GEQ, patching it to either an insert-out or insert-in will automatically assign the
other patch point to the same rack. Also, insert mode will automatically be switched on.
Additionally, if you defeat the insert-out or insert-in of a GEQ, the other patch point will
automatically be defeated and at the same time insert mode will automatically be switched off.
For more information on insert-in/out, see
page 21.
6.
To select the output source for a rack, press the OUTPUT PATCH button for that
rack.
The CH SELECT popup window will appear, allowing you to select the output destination for the
rack. Switch the list items as necessary, and select the output destination that you want to use.
When you select an output destination in the CH SELECT popup window, a dialog box will ask
you to confirm the change. To confirm the change, press the OK button.
NOTE
• You can make settings such that the confirmation dialog box will not appear (see
• Normally you will be able to specify two channels of output for a rack, but if the 31BandGEQ is
selected only one channel can be used.
1
1
Category select list
Selects the category of channel shown in the popup window.
• CH 1–32 ...................................... CH 1–32
• CH 33–64.................................... CH 33–64
117
Graphic EQ, effects, and Premium Rack
"Inserting an external device into a
2
3
*1, *2
*1, *2
channel" on
page 169).
Reference Manual