Parameter Assignment - Siemens simatic et 200s Operating Instructions Manual

2.7

Parameter assignment

Setting the Parameters
You set the parameters for the 1STEP 5V/204kHz by means of the device database file for
the ET 200S using the
Parameter List
You can enter the following parameters (default bold):
Parameters
Enable
Group diagnostics
Traversal Frequency
Base Frequency F in Hz
b:
Multiplier n: F = F *n
ss b
Acceleration/Delay
Time interval i:
a= F /(i* 0.128ms)
b
Digital Inputs
DI function
External STOP, limit switches
Causes of Parameter Assignment Errors
● Multiplier n = 0
● Multiplier i = 0
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
STEP 7
or COM PROFIBUS parameter assignment software.
Value range
Disable/enable
800/400/200/80/40/20/8/4
1...255
1...255
External pulse enable/
external STOP
Normally closed contact/ normally open
contact
1STEP 5V/204kHz
2.7 Parameter assignment
Explanation
The sensor supply short circuit error or
a parameter assignment error results in
a channel-specific diagnostics if you
have enabled group diagnostics.
It is the base value for setting the start-
stop frequency, the output frequency,
and the acceleration/delay.
Using the multiplier, you can set the
start-stop frequency in steps.
Using the multiplier, you can set the
acceleration/delay in steps.
-
-
43