Table 7-1 Terminal Assignment Of The 1Posu - Siemens simatic et 200s Operating Instructions Manual

1PosUniversal/Digital
7.2 Brief Instructions on Commissioning the 1PosU
Installation, Wiring, and Fitting
Install and wire the TM-E30S44-01 terminal module. Insert the 1PosU in the terminal module
(you can find detailed instructions in the
Table 7-1 Terminal assignment of the 1PosU
Terminal assignment
310
View
Connection of the Switches and
the Drive: Terminals 1-8
1: IN0
5: IN1
2: IN2
6: 24 V DC Supply for the
3: OUT0
7: 2L+
4: OUT1
8: OUT2
Distributed I/O Device
Remarks
Connection of the Position Encoder
with 5 V Differential Signals or 24 V
Signals: Terminals 9-16
Minus limit switch 9: A / D
Plus limit switch 13: /A / /D
Reducing cam; 10: 24 V DC
latch signal
14: M
switches
Travel minus or 11: B
rapid feed
Load voltage 15: /B
infeed for OUT0,
OUT1 and OUT2
Travel plus or 12: N / C
creep feed
Rapid/creep feed 16: /N / /C
and travel
plus/minus
Operating Instructions, 05/2007, A5E00124871-04
manual).
Track A / Data from
the SSI encoder
Power supply for the
position encoder
Track B
Track N / SSI clock
(clock line)
ET 200S Positioning