Siemens simatic et 200s Operating Instructions Manual page 229

Wire Break/Short Circuit of the Encoder Signals
Prerequisite:
To detect errors of the encoder signals, you must
•
enable the "Encoder signal diagnostics" parameter.
Causes:
Wire break or short circuit of the encoder signals at
•
terminals 1, 5 or 4, 8.
The parameters for the SSI encoder do not
•
correspond to the encoder connected.
What to Do:
Check the wiring and correct the short circuit.
•
Compare the parameter assignment with the
•
technical specifications of the encoder.
Acknowledge the error with the EXTF_ACK control
•
bit.
Errors in the Control of MODEs and JOBs
POS_ERR
Causes:
Certain requirements or conditions have not been
•
met at the start of a MODE
JOB_ERR
Causes:
Certain requirements or conditions have not been
•
met at the activation of a JOB
Generating a Channel-Specific Diagnostics
In the event of a parameter assignment error, the absence of load voltage, a short circuit of
the sensor supply or a wire break/short circuit of the encoder signals, the 1PosSSI/Digital
generates a channel-specific diagnostics on the connected CPU/master. To do this, you
must enable the Group Diagnostics parameter (see the
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
Response of the 1PosSSI/Digital
The current MODEs relative positioning and absolute
•
positioning are stopped; it is not possible to start a new run
in these MODEs.
– All 3 digital outputs are set to 0.
– Feedback bit POS_ERR = 1
– Feedback bit POS_DONE = 0
Feedback bit ERR_ENCODER=1
•
Feedback bit SYNC = 0
•
Generate channel-specific diagnostics
•
Waits for error acknowledgment EXTF_ACK
•
Inching MODE is not affected by this error.
•
Response of the 1PosSSI/Digital
The MODE started is not executed.
•
The current run is stopped.
•
– All 3 digital outputs are set to 0.
– Feedback bit POS_ERR = 1
– Feedback bit POS_DONE = 0
Response of the 1PosSSI/Digital
The activated JOB is not executed.
•
– Feedback bit JOB_ERR = 1
Distributed I/O Device
1PosSSI/Digital
5.6 Functions of the 1PosSSI/Digital
manual).
229