Table of Contents
Advertisement
IMPORTANT
checked. To avoid misleading results, ensure complete immersion of the aspirator tip in the dilution. Do
not remove the tube until you hear the beep.
4.
Label a clean empty tube with an ID
number.
5.
Make an accurate 1:3 (X3) dilution of
the sample. Pipet a minimum of:
50 µL of well-mixed, fresh whole
r
blood
100 µL of diluent
r
into a tube.
Note: Use larger volumes of diluent and
blood, if available, to minimize the
possibility of short sampling the
dilution. Be sure to maintain the proper
proportions for a times three dilution
(one part blood, two parts diluent).
6.
Mix the sample gently but thoroughly.
7.
Enter 1 to 16 alphanumeric characters
to identify the sample then press Û.
PN 4237519CB
Blood detectors are inactive in Predilute mode. Sample and aspiration integrity are not
b
c
SAMPLE ANALYSIS
CYCLING SAMPLES IN THE PREDILUTE MODE
1
2
3
3-11
Advertisement
Table of Contents
