Table of Contents
Advertisement
3.11 WORKLIST
The purpose of the Worklist is to assign additional sample identifiers such as patient name
and demographics, or additional information such as comments, before you cycle the sample.
This additional information prints on the report and is stored in the database with the results.
Worklist entries such as demographic data are best entered in batches.
Note: If you enter information to the Worklist during sample analysis or any time the
instrument is transmitting to the DMS, you need to verify that the entries were accepted. Any
demographic data entered during instrument transmission to the DMS is not entered into the
DMS and does not appear on the sample printout.
The DMS matches sample results with additional information based on ID#1.
The Worklist is a list of work to be done. Once the DMS matches the results to preassigned
data, the entry disappears from the Worklist.
You can preassign the Worklist manually or automatically. The procedure for manual entry is
presented in this section. See Heading 3.12, Host Worklist for information about automatic
preassignment.
Automatic Sequencing Set Up
To minimize typing, you can set up the Worklist to automatically sequence ID#1, Sequence #,
and Secondary mode sample reference number. You set up which ones you want to
automatically sequence and the starting number for each. When you preassign the Worklist,
pressing Û automatically enters the next number in the sequence.
1.
Access the Worklist screen:
at the Run Samples screen,
r
press Ý + W
at the Access screen,
r
press Í
at the Main Menu, select
r
Sample Analysis
Press Ô
2.
automatic sequencing area at the top of
the screen.
PN 4237519CB
OR
WORKLIST
OR
.
Worklist
tt
Seq
to move the cursor to the
3
SAMPLE ANALYSIS
WORKLIST
3-19
Advertisement
Table of Contents
