Verify Mode - YASKAWA CIMR-G7U Technical Manual



Verify Mode

Verify mode is used to display any parameters that have been changed from their default settings in a
programming mode or by autotuning. "None" will be displayed if no settings have been changed.
Of the environment mode settings, only A1-02 will be displayed if it has been changed. Other environment
modes settings will not be displayed even if they have been changed from their default settings.
Even in verify mode, the same procedures can be used to change settings as are used in the programming
modes. Use the Increment, Decrement, and Shift/RESET Keys to change the frequency. The user parameter
will be written and the monitor display will be returned to when the DATA/ENTER Key is pressed after
changing the setting.
Example Operations
An example of key operations is given below for when the following settings have been changed from their
default settings: b1-01 (Reference Selection), C1-01 (Acceleration Time 1), E1-01 (Input Voltage Setting), and
E2-01 (Motor Rated Current).
Mode Selection Display
DATA
ENTER
-ADV-
** Main Menu **
Programming
MENU
-VERIFY-
** Main Menu **
Modified Consts
MENU
-A.TUNE-
** Main Menu **
Auto-Tuning
MENU
-DRIVE-
** Main Menu **
Operation
MENU
-QUICK-
** Main Menu **
Quick Setting
MENU
Monitor Display
A B
DATA
ENTER
-VERIFY-
Reference Source
b1-01=0
*0*
Terminals
"1"
ESC
-VERIFY-
Accel Time 1
C1-01=200.0Sec
-VERIFY-
Input Voltage
E1-01=200VAC
-VERIFY-
Motor Rated FLA
E2-01=2.00A
A B
Fig 3.6 Operations in Verify Mode
Drive Mode Indicators
Setting Display
DATA
ENTER -VERIFY-
Reference Source
b1-01= 0
*0*
Terminals
"1"
ESC
DATA
-VERIFY-
ENTER
Accel Time 1
C1-01=0200.0Sec
ESC
DATA
-VERIFY-
ENTER
Input Voltage
E1-01= 200VAC
ESC
DATA
-VERIFY-
ENTER
Motor Rated FLA
E2-01= 2.00A
ESC
13
3-