YASKAWA CIMR-G7U Technical Manual page 195

Name
Parameter
Number
Display
Fault Trace/ Clears the fault memory
Fault History contained in the U2 and U3
Clear monitors.
o2-12 Function 0: Disabled - no effect
1: Enabled - resets U2 and
Fault Trace
U3 monitors, and returns
Init
o2-12 to zero.
kWh User Used to reset the kilowatt-
Monitor hour monitor U1-29 to zero.
Initialization 0: Disabled - no change
o2-14
1: Enabled - Resets U1-29 to
kWH
zero and returns o2-14 to
MonitorClear
zero.
* Factory settings will vary based on drive capacity (values given here are for 208-240Vac, 0.4kW).
 Copy Function: o3
User parameters for the copy function are shown in the following table.
Name
Parameter
Number
Display
Copy This parameter controls the
Function copying of parameters to and
Selection from the Digital Operator.
0: COPY SELECT (no
function)
1: INV --> OP READ - All
parameters are copied
from the Drive to the
Digital Operator.
2: OP --> INV WRITE - All
parameters are copied
from the Digital Operator
to the Drive.
o3-01
3: OP<-->INV VERIFY -
Copy
Parameter settings in the
Function Sel
Drive are compared to
those in the Digital
Operator.
Note:When using the copy
Copy Enables and disables the
Allowed Digital Operator copy
Selection functions.
0: Disabled - No Digital
o3-02
Operator copy functions
Copy
are allowed.
Allowable
1: Enabled - Copying
allowed.
Setting Factory
Description
Range Setting
0 to 1
0 to 1
Setting Factory
Description
Range Setting
0 to 3
function, the Drive
model number (o2-04),
software number
(U1-14), and control
method (A1-02) must
match or an error will
occur.
0 to 1
User Parameter Tables
Control Methods
Change
Open
V/f
during
Loop
V/f with
Operation
Vector
PG
1
0 No A A A
0 No A A A
Control Methods
Change
Open
V/f
during
Loop
V/f with
Operation
Vector
PG
1
0 No A A A
0 No A A A
Open
MODBUS
Flux Loop
Register
Vector Vector
2
A A 510H
A A 512H
Open
MODBUS
Flux Loop
Register
Vector Vector
2
A A 515H
A A 516H
83
5-