Basic Flow Of Scanning Operation - Fujitsu fi-6800 Operator's Manual

Chapter 1 Scanner Overview

1.11 Basic Flow of Scanning Operation

This section explains about the basic flow of scanning
operations.
In order to perform a scan, you need a scanner driver and an
application that supports the scanner driver.
The following scanner drivers and image scanning
applications are bundled with the scanner:
Scanner driver

- PaperStream IP (TWAIN) driver
Conforms to the TWAIN standard. Used when you operate the
scanner using TWAIN-compliant 32-bit applications.
- PaperStream IP (TWAIN x64) driver
Conforms to the TWAIN standard. Used when you operate the
scanner using TWAIN-compliant 64-bit applications.
- PaperStream IP (ISIS) driver
Conforms to the ISIS standard. Used when you operate the
scanner using ISIS-compliant applications.
Image Scanning Application

- PaperStream Capture
Supports the PaperStream IP (TWAIN) driver and the
PaperStream IP (ISIS) driver
For details about the scanner driver, refer to the

PaperStream IP driver Help.
For details about the image scanning application, refer to

the PaperStream Capture Help.
1
Turn on the scanner.
For information on how to turn on the power, refer to
Power ON/OFF" (page 16).
When connected via SCSI, turn on the scanner and

confirm that [Ready] is displayed on the LCD before
you turn on the computer.
When switching the connectors, make sure to power

off the scanner and the computer first.
2
Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
For information on how to load documents, refer to
Load Documents" (page 30).
TOP
Contents
Index
Introduction
Scanner
"1.3 Turning the
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
"Chapter 2 How to
Troubleshooting
Operational
Settings
Appendix
Glossary
27