YASKAWA mp2500 User Manual page 345

Appendixes
Builder
S
Start address is not set.
Start page No. is out of range.Set a
number from 0 to 255.
Start sheet No. is out of range.Set
a number from 0 to 9.
T
The address is out of range.
Test run is runing now. Fail to
start test run.
The number of functional object
will exceed the maximum limit.
Operation cancelled.
The setting is not completed. This
item must be set.
The setting of border value is not
correct.
The value is out of range.
To reference a string indirectly, set
both File Name and Address for
Selecting a Line.
The leading number of the address
for the CB memory must be a
multiple of 16.
Total number of alarms exceeds
5000.
Total number of functional object
will exceed the limit. Can not
continue operation.
Message
Appendix − 11
Appendix-4 Error Messages
Solution
Specify the starting number of the address
you wish to replace in [Start Address] in
the [Replace] dialog box.
The sheet screen page number must be
between 0 and 255.Set the screen page
number between 0 and 255.
The sheet screen page number must be
between 0 and 9.Reset the sheet screen
page number between 0 and 9.
Reset the address in the [Address Setting]
dialog box so that it is within range.
Exit the test, then execute the test again.
Limit the number of functional objects in a
single screen to within 1024.
♦
Checking the number of functional
objects being used
Check the number of functional objects
being used in the screen by viewing the
Functional object Usage ([Tools] –
[Functional Object Used])
When the [OK] button in the message
dialog box is clicked, the cursor will jump
to the item whose property needs to be set.
Make the correct settings for the boundary
values (maximum value, separation value,
and minimum value).
Specify a value within range.
Set the [Indirect Reference of String] –
[File Name] and [Address for Selecting a
Line] fields in the [Label] tab of the label
properties.
If assigning the CB memory for the
Register in the Device layout box, enter the
values as a multiple of 16 in the Leading
box.
The maximum number of alarm/event
registries is 5000. Reduce the number of
alarm/event registries from the
[Alarm/Event Setting] dialog box so that
the total number is within 5000.
The project file may be corrupted. If you
created a backup file, restore the backup
file in [Project Maintenance] ([File] –
[Project Maintenance]).