YASKAWA mp2500 User Manual page 179

Chapter 5 Operating Objects
Builder
Address setting
Sets the address type and number in the [Address Setting] dialog box.
Select [Shared memory] from the address types to specify shared memory.
The address types that are displayed vary according to the selected
destination.
Number
1) Communications
selection
2) Type select
3) High-speed access If using high-speed communications, select the ON check
4) Communications
address
5) Bit position
Item
Select the communications: Shared memory, 1:CP1 (motion
card in slot 1), or 2:CP2 (motion card in slot 2).
Select the classification type for the communications
address.
box.
To enter an address number, click the buttons 0 to 9 or A to
F.
Use the CLR button to clear a specified address.
Use the BS button to delete the last character of an address.
Select the bit position in the Bit position box.
If the address has been set to a character from A to F and a
bit register is used, set the bit position to a number from 10
to 15.
5 − 57
5-7 Address Setting
1)
4)
5)
2)
3)
Explanation