YASKAWA mp2500 User Manual page 342

Appendixes
Builder
F Failed to import CSV file.
Failed to register.
Failed to save file.
Failed to use.
Failed to write to a file. Check the
free space and perform writing
again.
Failure occurred in reading and
writing of a file.
File check sum error
File name is incorrect. Input
correct file name.
File not found.Please verify the
correct file name was given.
File save error.
Functional objects overlap.To
permit overlapping, change the
setting from [Tools] - [Options].
Frame size is not set.Please be sure
to set this item.
Frame size is out of range. Please
set the value from 0 to 16.
Message
Appendix − 8
Appendix-4 Error Messages
Solution
Check if the file you tried to import is a
CSV file, and try again.
Check if the specified category is being
used by another project and try again. If
not, then the data may be corrupted.
Failed to save the file probably due to
insufficient free space in the hard disk.
Increase the amount of free space in the
hard disk and try again.
Check if the specified category or file is
being used by another project and try
again. If not, then the data may be
corrupted.
Failed to save the file probably due to
insufficient free space in the hard
disk.Increase the amount of free space in
the hard disk and try again.
Confirm that whether a file is reading only
or not.
Or the file may be broken.
Delete CM.INI from a project folder, and
then execute the save for project.
CM.INI is newly made.
The file is corrupted. Recreate the file from
the backup data.
Specify the file name using the correct
format.
Specify an existing project name in the
[Open project] dialog box.
Increase the free space on the PC side.
Avoid overlapping the functional objects. If
you want to overlap objects, remove the
check from the [Prohibit functional objects
from overlapping] box in the [Edit/Disp] tab
of the [Options] dialog box ([Tools] –
[Options]).
Set the peripheral border size in the
[Frame] tab in the functional object
properties.
Specify the border size in the [Frame] tab
of the functional object properties between
0 and 16.