Oce CS9360 User Manual page 76

TIP
The length of media that is fed (feeding length) for initial adjustment printing is normally

set at 250 mm.
If you increase the feeding length, the accuracy of the Media feed compensation

improves.
To change the feeding length, press [+] or [-] and change the set value.
b. Press [Enter].
"Printing" is displayed.

Starts initial adjustment printing.

1
N°.
1
2
When the initial adjustment printing is complete, the printer enters Normal.

c. After the initial adjustment printing, cut the media.
4.4.3 Cutting media
Step 3:
Measure the distance between the two pluses in the initial adjustment print using a ruler.
Step 4:
Sets up Initial Adjust Change.
a. Press the [+] or [–] to select "PF2: Initial Change".
b. Press [Enter].
"Init.: 250.0/250 mm" is displayed.

c. Press [+] or [-] and enter the measured value in step 3.
d. Press [Enter].
The initial adjustment value is saved.

"PF2: Initial Change" is displayed.

Step 5:
Performs Confirm Print.
a. Press [+] or [–] to select "PF3: Confirm Print".
FeedLength
Media feeding direction
Name
4-76
CS9360 User's Guide
2
1