Typical Values For Transmission Information Parameters; Red Flags On Transmission Information Page; Terminal Status Page; Table 15: Transmission Information Parameters - Typical Values And Range - Hughes HN9500 Installation Manual

System Control Center

Typical values for Transmission Information parameters

Table 15: Transmission Information parameters – typical values and range
Parameter
Transmit Status
Tx Error
Transmit Path Fault
Total Satellite Packets Transmitted
Total Satellite Packets Dropped

Red flags on Transmission Information page

Terminal Status page

The operational parameters listed on the Transmission Information page are shown in a tabular
format. The first (left) column identifies the parameter categories:
• Satellite Interface Statistics – Contains information on transmit status and signal strength,
as well as transmission-related error messages.
• Traffic Statistics: Transmit – Contains statistical information on the specific data transmitted
to the satellite from this satellite router.
The following table lists typical values and the range of values for parameters on the Transmission
Information page. This information may help you understand the values displayed by a customer's
satellite router.
To see the definition of any parameter, click the parameter name on the screen.
Typical values
Satellite Interface Statistics (parameter category)
Traffic Statistics: Transmit
If you see a red flag next to Transmit Status on the Transmission Information page, see Transmit
Status in Table 12: Red flags on System Status page
Status in that table also applies to the Transmission Information page.
The Terminal Status page displays information about the operational state of the satellite router
and operational statistics such as messages and packets sent, received, and dropped. It indicates
whether acceleration is enabled and provides a count of traffic that moves across the LAN to
the satellite router.
Up Up – The router is transmitting
signals to the satellite.
Down – The router is not
transmitting signals to the satellite.
≥ 0 Any whole number.
OK Not applicable (parameter reserved
for future use).
≥ 0 Any whole number.
≥ 0 Any whole number.
on page 76. The information for Transmit
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G
Chapter 9
Range of values
81