Typical Values For Transmission Information Parameters; Table 9: Transmission Information Parameters - Typical Values And Range - Hughes HN9500 User Manual

Chapter 2

Typical values for Transmission Information parameters

Table 9: Transmission Information parameters – typical values and range
Parameter
Transmit Status
Tx Error
Transmit Path Fault
Total Satellite Packets Transmitted
Total Satellite Packets Dropped
HN9500 Satellite Router User Guide
28
1037737-0001 Revision E
Figure 18: Transmission Information page
The operational parameters listed on the Transmission Information page are shown in a tabular
format. The first (left) column identifies the parameter categories:
• Satellite Interface Statistics – Contains information on transmit status and signal strength,
as well as transmission-related error messages.
• Traffic Statistics: Transmit – Contains statistical information on the specific data transmitted
to the satellite from this satellite router.
The following table lists typical values and the range of values for parameters on the Transmission
Information page. This information may help you understand the values displayed by your
satellite router.
To see the definition of any parameter, click the parameter name on the screen.
Typical values
Satellite Interface Statistics (parameter category)
Traffic Statistics: Transmit
Up Up – The router is transmitting
signals to the satellite.
Down – The router is not
transmitting signals to the satellite.
≥ 0 Any whole number.
OK Not applicable (parameter reserved
for future use).
≥ 0 Any whole number.
≥ 0 Any whole number.
System Control Center
Range of values