Terminal Info Parameters; Table 7: Parameters In Terminal Info Section (Appears On Two Installation Screens) - Hughes HN9500 Installation Manual

Commissioning the satellite router
Error message
Relocation Not
Authorized
SAM ESN Blacklisted
by Operator
ST ESN Already In
Use
ST Replacement Not
Authorized
Invalid Site Name.
Please verify name
and try again.
Group Barred
Individually Barred
Registration Services
Disabled
Rx Air Interface Down
Tx Air Interface Down

Terminal Info parameters

Table 7: Parameters in Terminal Info section (appears on two installation screens)

Parameter
Terminal Operation
State
Reason
Attempting to register previously
registered ST Site Name or ST Site ID
using latitude and longitude values outside
of assigned microcell.
The satellite router's security access
module is barred for a reason such as
nonpayment for service.
Attempting to register a previously
registered ST Site Name or ST Site ID at
a different location.
Attempting to register different equipment
using a previously registered ST Site
Name or ST Site ID.
The ST Site Name sent by the satellite
router is not known at the NOCC.
Management reasons for registration failure
The satellite router is included in a group
of routers that are barred from service.
The satellite router is barred from service.
Registration services are not available
because internal maintenance is
underway.
Satellite receive link is down.
Satellite transmit link is down.
The following table explains the parameters in the Terminal Info section, which is the common
lower part of the two screen shown in
Figure 21: Terminal Initialization Sequence complete
Possible values
Up
Down
Call Installer Support with site name to
resolve the issue.
Call Installer Support with the satellite
router's ESN and ST Name to resolve the
issue.
Call Installer Support with the satellite
router's ESN to resolve the issue.
Call Installer Support with site name to
resolve the issue.
Check to make sure the Terminal Site
Name is the correct name and was
entered correctly. If the name was
correctly entered, call Installer Support.
Call Installer Support with site name to
resolve the issue.
Call Installer Support with site name to
resolve the issue.
No action is required. Registration service
will be enabled when maintenance is
complete.
Verify the installation, for example, check
cable connections and connectivity to the
antenna. If the problem is not corrected,
repoint the antenna.
Verify the installation, for example, check
cable connections and connectivity to the
antenna. If the problem is not corrected,
repoint the antenna.
Figure 17: Terminal Pointing Info screen
on page 34.
Left column
This is a summarized state. Up indicates satellite router
is healthy and able to transmit and receive. Down
HN9500 Satellite Router Installation Guide
Chapter 5
Corrective action
on page 25 and
Comments
1037736-0001 Revision G
37