Transmission Information Page; Examining Transmit Status - Hughes HX90 User Manual

Transmission Information page

Parameter
Transmit Status
Number of Successful
Transmissions
Number of Failed Transmissions
Number of Packets Submitted for
Transmission

Examining transmit status

Chapter 2 • System Control Center
30
1039457-0001 Revision A
The Transmission Information page shown in Figure 16 displays information about
data transmissions from the satellite router. The information on this screen may be
useful to a service provider representative if you need help in resolving a problem.
Figure 16: Transmission Information page
The parameters listed on the Transmission Information page are explained in the
following table.
Table 6: Transmission Information page parameters
Indicates if the transmit data path is operational. Click the displayed
TxCode for explanation of the displayed code.
Number of frames transmitted to the satellite.
Number of frames that could not be sent. A continuously increasing
value indicates a transmission problem. If a low value is displayed and
does not increase, and the system is functioning, there is no reason for
concern.
Total number of data packets queued for transmission to the satellite
since the router was last restarted.
You can check the Transmit Status parameter to find out if the transmission data path
is operational or if there is a problem. Normal transmit status is indicated by the
message Transmitter ready (
Explanation
).
TxCode 8