Table of Contents
Advertisement
Installing the satellite router
page 21). The Installation Parameters screen is the first of several screens that appear within
the Advanced Configuration and Statistics screen as you install the router.
Figure 13: Installation Parameters screen
Parameters screen with parameters entered. You must enter the specific parameters for the
site where you are installing the satellite router, as listed on the Installation Reference Sheet.
Do not copy parameters from this example.
Figure 13: Installation Parameters screen
4. For each of the following parameters, select the value listed on the Installation Reference
Sheet:
• Terminal site name – Note that this field is case-sensitive.
• A code – Satellite orbital location. Select the value 0949505, which corresponds to the
orbital location 94.950° W.
• B code – Antenna size. The B code and C code values are used to ensure that the satellite
router transmits at the correct maximum power.
•
B code
0749
0988
1208
1804
• C code – ODU power
C code
000103
000200
on page 21 is an example, showing the Installation
Antenna size
0.74 m
0.98 m
1.2 m
1.8 m
Nominal ODU power
1 W
2 W
HN9500 Satellite Router Installation Guide
1037736-0001 Revision G
Chapter 3
21
Advertisement
Table of Contents
Troubleshooting
